Notice PHILIPS AT 890

« er 8 Cleaning brush 9 Battery symbol and plug symbol (AT940 only) 10 Shaver on/off button (AT940 only) 11 Trimmer release slide (AT940/AT893/AT891/AT890 only) 12 Trimmer (AT940/AT893/AT891/AT890 only) Not shown: Storage pouch (AT940/AT893/AT891/AT890 only) Note: You can ?nd the type number on the back of the shaver. Important Read this user manual carefully before you use the appliance and the charging stand (AT940 only). Save it for future reference. Danger -Make sure the adapter does not get wet. Warning -The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. -This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -Children should be supervised to ensure that they do not play with the appliance. -Always unplug the shaver before you clean it under the tap. Caution -Never use water hotter than 80°C to rinse the shaver. -Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. -The shaver and the other accessories are not dishwasher-proof. ENGLISH -Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. -Do not use the shaver, adapter, charging stand or any other part if it is damaged, as this may cause injury. Always replace a damaged adapter or charging stand with one of the original type. -Use, charge and store the appliance at a temperature between 10°C and 35°C. -Always place and use the shaver on a surface that is ?uid-resistant. -Only use the adapter, charging stand and accessories supplied. -Always put the protection cap on the shaver to protect the shaving heads when you are travelling. -If the shaver is subjected to a major change in temperature, pressure or humidity, let it acclimatise for 30 minutes before you use it. -Do not immerse the charging stand in water or any other liquid, nor rinse it under the tap. Compliance with standards -This shaver complies with the internationally approved safety regulations and can be safely used in the bath or shower and cleaned under the tap. -This Philips appliance complies with all standards regarding electromagnetic ?elds (EMF). If handled properly and according to the instructions in this user manual, the appliances are safe to use based on scienti?c evidence available today. General -The appliance is equipped with an automatic voltage selector and is suitable for mains voltages ranging from 100 to 240 volts. -The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts. Charging Note: The shaver cannot be used directly from the mains. AT940/AT893/AT891/AT890 only: It takes approx. 1 hour to fully charge the shaver. AT754/AT753/AT752/AT751/AT750: It takes approx. 8 hours to fully charge the shaver. When you charge the shaver for the ?rst time or after a long period of disuse, let it charge until the charging light lights up continuously. A fully charged shaver provides up to 21 (AT940), 17 (AT893/AT891/ AT890) or 14 (AT754/753/AT752/AT751/AT750) cordl... »