Notice AEG Voxtel C110

« ng: The caller display will not work and you will only be able to make and receive basic handset calls without batteries installed. 3 INTENDED USE This telephones is intended to be connected to a public analogue telephone network or to an analogue extension of an approved compatible PBX system. 4 GETTING TO KNOW YOUR PHONE (See P1) #Meaning 1LCD screen 2Ringer light indication 3 Caller display list and up/down buttons 4New calls LED 5Delete button 6Dial button 7Outgoing calls list button 8Menu button 9Memory button 10 Direct dial memory buttons4 11Mute button 12Hold button 13Recall/?ash button 14Pause button 15Last number redial button 16Speakerphone light 17Handsfree button 18Store button 19Handset cord socket on the handset 20Handset cord socket on the base unit 21Ringer high/low switch 22Phone line socket on the base unit 23 Speaker volume control 5 INSTALLATION 1. Locating the base unit (See P2 and P3) The base unit should be placed on a level surface, in a position where: the telephone line cable will reach your telephone line socket or extension socket. it is not close to a sink, bath or shower, or anywhere else where it might get wet. it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, ?uorescent lights, etc. 2. Installing (or replacing) the battery (See P4) IMPORTANT: Before removing the battery compartment cover, always make sure the base unit is disconnected from the telephone line. Install 3 Alkaline AAA batteries into the battery compartment in the underside of the base and re-?t the cover before use. Note: 1) Please do NOT use Rechargeable batteries in this phone. 2) Batteries are not included with the unit. 3) The battery life is typically about 6 months, depending on usage. When the battery is low , will ?ash on the display. If you do not replace the batteries, they will become totally discharged and your display screen will not work. You may lose all the telephone memories and settings.5 UK 3. Plug the coiled handset cord into the handset 19. Plug the other end into the socket on the side of the base unit 20. 4. Place the handset on the base unit. 5. Plug the telephone line cord into the phone line socket at the back of the base unit 22 and the other end into your telephone line socket. 6. Lift the handset and check for dial tone in the earpiece. 6 WALL MOUNT INSTALLATION To place the Voxtel C110 on a wall, connect the wall mount bracket to the bottom of the phone in the slots near the front of the base as shown below Insert the rigid clips of the bracket into the slots on the bottom of the phone (nearer the front of the base). Press down ?rmly until the ?exible clips click into place in the slots nearer the centre of the base. To remove the bracket, (1) pinch the ?exible clips, (2) back the bracket, and then (3) slide up and forward as shown below.6 Mark two points on the wall that are 80 mm apart to lay the ?xing centres as shown below. BE CAREFUL to check that there are no pipes or electrical wires hidden in the wall. Fix two screws (7mm head screws required, not supplied) at the marked locations, leaving approximately 7mm between the wall and the screw head. Hang the telephone on the screws using the wall mount slots. You may need adjust the screws so that the telephone is securely ?xed and does not wobble. Place the handset on the cradle with the parking hook on the cradle... »