Notice AEG Voxtel C100

« button 8Last number redial button 9In use light - turns on when on a call 10Ringer hi/low switch4 4 INSTALLATION 1. Locating the base unit (See P2 and P3) The base unit should be placed on a level surface, in a position where: the telephone line cable will reach your telephone line socket or extension socket. it is not close to a sink, bath or shower, or anywhere else where it might get wet. it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, ?uorescent lights, etc. 2. Plug the coiled handset cord into the handset. Plug the other end into the socket on the side of the base unit. 3. Place the handset on the base unit. 4. Plug the telephone line cord into the phone line socket at the back of the base unit and the other end into your telephone line socket. 5. Lift the handset and check for dial tone in the earpiece. 5 WALL MOUNT INSTALLATION To place the Voxtel C100 on a wall, connect the wall mount bracket to the bottom of the phone in the slots near the front of the base as shown below. Insert the rigid clips of the bracket into the slots on the bottom of the phone (nearer the front of the base). Press down ?rmly until the ?exible clips click into place in the slots nearer the centre of the base. To remove the bracket, (1) pinch the ?exible clips, (2) back the bracket, and then (3) slide up and forward as shown below.5 UK Mark two points on the wall that are 80 mm apart to lay the ?xing centres as shown below. BE CAREFUL to check that there are no pipes or electrical wires hidden in the wall. Fix two screws (7mm head screws required, not supplied) at the marked locations, leaving approximately 7mm between the wall and the screw head. Hang the telephone on the screws using the wall mount slots. You may need adjust the screws so that the telephone is securely ?xed and does not wobble. Place the handset on the cradle with the parking hook on the cradle arranged to ?t in the parking recess under the earpiece on the handset. 6 TELEPHONE OPERATION 6.1 Ringer volume The ringer high/low switch located at the back of the base unit allows you to adjust the volume of the ringer. High volume Low volume 6.2 Making a call Lift the handset, listen for a dial tone. Dial the telephone number you wish to call. To end the call, return the handset to the base unit. 6.3 To answer a call Lift the handset to answer a call. 6.4 To end a call Replace the handset on the base unit cradle. 6.5 Last number redial Lift the handset and listen for dial tone. Press the redial button . >The phone automatically dials the last number you called (maximum of 32 digits). parking hook lay the centres as 80 mmparking recess rotate6 6.6 Mute Function During a call press the mute button . >When the mouthpiece is muted, the person at the other end of the call cannot hear you out you can hear his side. To get back to the call, press the mute button again. 6.7 Use on PBX If you are using your Voxtel C100 phone on a PBX, and the PBX user guide tells you to press recall or ?ash; Press the recall button on your phone. 6.8 Inserting a pause in the dialling sequence For some switchboard systems, an access number must be dialled (usually an 0 or 9) to get another dial tone and an outside line. Press the pause button immediately after the access number, a pause of about 3.6 seconds will be entered, and the desired number can be... »