Notice DORO TEL2I

« appuyant sur la touche correspondante. 3. Composez le numéro de téléphone souhaité. Appuyez sur p et reposez le combiné. Composer un numéro en mémoire directePrenez le combiné et choisissez la mémoire désirée(M1-M3). Enregistrement de numéros en mémoire abrégée1. Prenez le combiné et appuyez sur p (ne tenez pas compte de la tonalité). 2. Appuyez sur M. Sélectionnez ensuite la plage de mémoire souhaitée 0-9. 3. Composez le numéro de téléphone souhaité. Appuyez sur p et reposez le combiné. Composer un numéro en mémoire abrégée 1. Prenez le combiné et appuyez sur M. 2. Sélectionnez le numéro de mémoire abrégée en appuyant sur une des touches 0-9. Réglage de la sonnerie 1. Prenez le combiné (ne tenez pas compte de la tonalité) et appuyez p et sur #. This device is intended for the analogue telephone network lines in AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT, LU, MT, NL, NO, PL, PT, RO, SI, SK, SE. Connection Connect the cord to the network socket. Mute buttonThe microphone can be turned off/on, press z. Redial buttonPress the redial button r. Volume controlThe volume may be adjusted using {/}. MemoryThe telephone will store 3 one-touch(M1-M3) and 10 two-touch memories (up to 21 digits). Storing One-touch Memories 1. Lift the handset, press p(ignore the dial tone). 2. Press desired location M1-M3. 3. Enter the number. Press p, replace the handset. Dialing using One-touch MemoriesLift the handset and press desired location M1-M3. Storing Two-touch Memories 1. Lift the handset, press p(ignore the dial tone). 2. Press M. 3. Press desired location 0-9. 4. Enter the number. Press p, replace the handset. Dialing using Two-touch Memories 1. Lift the handset, press M. 2. Press desired location 0-9. Press r if you want a pause in the telephone number. Ringer 1. Lift handset, press p # (ignore dial tone). 2. Select ring signal by pressing 0-9 in accordance with the table below. 3. Press p and replace the receiver. Melody type Key/level Melody A ....................1=Low, 2=Normal, 3=High Melody B ....................4=Low, 5=Normal, 6=High Melody C ....................7=Low, 8=Normal, 9=High Off* .............................0 EnglishFrançais * If the key 0 is selected, the ring signal will be turned off until the next time the receiver is lifted. After that, the ring signal will revert to the previous setting. Wall mounting 1. Secure two screws, vertically positioned 83 mm apart. 2. The screws should locate into the two keyholes on the back of the telephone. 3. Remove the hanging peg (located by the hook switch) by pushing it upwards. 4. Rotate the hanging peg 180 degrees, and then replace it. Declaration of conformityDoro declares that the apparatus Doro Tel 2i complies with the essentialrequirements and other relevant positions of Directive 1999/5/EC, 2002/95/EC. A copy of the Declaration of Conformity can be found at www.doro.com/dofc TroubleshootingCheck that the telephone cord is undamaged and properly plugged in. Disconnect any additional equipment that may be connected. If the problem is resolved the fault is with the other equipment.Test the equipment on a known working line, if the product works then the fault is with the line. If you are still experiencing dif?culties, contact the place of purchase. GuaranteeThis product is guaranteed for a period of 12 months from the date of purchase.Proof of purchase is required for any s... »