Notice ION Proflash

« RCA AUDIO OUTPUT CABLES – These cables should be plugged into the audio inputs of your home stereo system. (Please note: you can still copy records to your USB device or SD card, even if the audio outputs of the turntable are not connected to a stereo system). 4. AUDIO INPUT – Connect a tape player, reel-to-reel machine, or other audio source to this input using a 1/8” stereo cable. Any signal entering this input will be included in the playback or recording mix. TOP PANEL FEATURES 1. PLATTER – This platter must be securely fastened to the turntable prior to operation. The Motor Drive Belt can be found on the drive ring underneath the platter. 2. 45 RPM ADAPTER HOLDER – Holds the included 45 RPM adapter. When not using the adapter, please place it in this holder. 3. TONEARM – PROFILE FLASH comes with a ready to use pre-balanced TONEARM and cartridge. The TONEARM can be raised and lowered by hand, or by pressing the RAISE / LOWER LEVER. Please note that the TONEARM needs to be moved away from resting position (on the ARM CLIP) for the turntable motor to activate. When the TONEARM is placed back in its resting position, the turntable motor will deactivate. 4. ARM CLIP – This specially designed arm clip secures the tone arm while at rest or when not in use. The arm clip has been designed to remain in the up position while unlocked. 5. RAISE / LOWER LEVER – Raises and lowers the tonearm. IMPORTANT Make sure that the slipmat is always placed on top of the platter while using the turntable. Failure to use the slipmat may cause damage to your media as well as damage to the turntable. Remove the plastic cartridge cover (needle cover) before operating the turntable. 1234 13 4 5 2 2 FRONT PANEL FEATURES Y4 1011129 5 6788 123 1. USB SLOT – Insert USB thumb-drive or connect USB hard- drive (FAT16 or FAT32 only) to this input. Note: PROFILE FLASH does not support USB hubs. 2. SD CARD SLOT – Insert SD card into this slot until it clicks. To eject it, push it in once until it clicks, then remove it from the slot. 3. 33 / 45 RPM BUTTON – This button controls the RPM of the turntable platter. 4. STOP RECORD – This button stops the turntable motor. 5. LCD – Shows information pertinent to unit operation. 6. PLAY / PAUSE – Press this button to play. While playing, press again to pause. While paused, press again to resume playback. 7. STOP () – Press this button to stop playback (or recording). 8. SKIP / – Skips to the previous track or next track (respectively). Press and hold the button down to rewind or fast forward (respectively) through the current track. 9. REC – Press this button to enter Record Mode. Record Mode allows you to record music from the turntable platter, or from external audio devices connected to the LINE IN, directly to a connected USB or SD device. 10. NEXT FOLDER – Press this button to skip to the next folder on your connected device and play the first available MP3 in that folder. 11. PLAY MODE – Press this button to select how PROFILE FLASH will play your tracks: a. Repeat: The current track will repeat. b. Repeat All: The entire collection of tracks on your connected device will repeat. c. Repeat Folder: The collection of tracks in the current folder will repeat. d. Random: The entire collection of tracks on your connected device will play in random... »