Notice PHILIPS QC5360/31

« ppliance is switched off. 2 Insert the appliance plug into the socket of the appliance and put the adapter in the wall socket. ,The charging light starts ?ashing green to indicate that the appliance is charging. ,When the batteries are fully charged, the charging light lights up green continuously. After 30 minutes the charging light goes out to save energy. Using the appliance Note: You can also use the appliance directly from the mains when the battery is empty. Clipping with comb The appliance comes with 1 comb for different hair lengths. The hair length settings are indicated in millimetres on the comb. The settings correspond to the remaining hair length after clipping. ENGLISH 1 Slide the comb straight into the guiding grooves on both sides of the handle (‘click’). 2 To set the comb to the desired setting, press the setting selector (1) and slide the comb to the desired hair length setting (2). ,The settings in the window show the selected hair length in millimetres after cutting. Tip: Write down the hair length settings you selected to create a certain hairstyle as a reminder for future clipping sessions. 3 Slide the on/off slide upwards to switch on the appliance. 4 Move the appliance through the hair slowly. Tips -To clip most effectively, move the appliance against the hair growth direction. -Since all hair does not grow in the same direction, you need to move the appliance in different directions (upwards, downwards and across). -Make sure that the ?at part of the comb is always fully in contact with the scalp to obtain an even result. -Make overlapping passes over the head to ensure that you cut all the hair that needs to be cut. 5 Regularly remove cut hair from the comb. If a lot of hair has accumulated in the comb, remove the comb from the appliance and blow and/or shake the hair out of it. Contouring without comb You can use the appliance without comb to clip hair very close to the skin (0.5mm) or to contour the neckline and the area around the ears. Be careful when you clip without comb because the cutting element removes every hair it touches. 1 Press the setting selector and slide the comb up, then pull the comb off the appliance. 2 Before you start to contour the hairline around the ears, comb the hair ends over the ears. ENGLISH7 3 Slide the on/off slide upwards to switch on the appliance. 4 Tilt the appliance in such a way that only one edge of the cutting element touches the hair ends when you shape the contours around the ears. Only cut the hair ends. The hairline should be close to the ear. 5 To contour the neckline and sideburns, turn the appliance and make downward strokes. Move the appliance slowly and smoothly. Follow the natural hairline. Cleaning Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol, acetone or ethereal oils to clean the appliance. Never immerse the appliance in water or any other liquid, nor rinse it under the tap. Note: The appliance does not need any lubrication. 1 Switch off the appliance and disconnected it from the mains. 2 Remove the comb from the appliance and clean it with the cleaning brush. 3 Push the centre top end of the cutting element upwards with your thumb until it opens. 4 Use the cleaning brush to remove the cut hair. ENGLISH89 Introduktion Tillykke med dit køb og velkommen til Phi... »