Notice SHARP LC20B2EA

« le direttive 89/336/EEC e 73/23/EEC come emendata dalla direttiva 93/68/EEC. ? e??at?stas? a?t? a?tap????eta? st?? apa?t?se?? t?? d????? t?? ????pa???? ???s?? 89/336/?? ?a? 73/23/??, #p?? ? ?a???sµ? a?t? s?µp???????a? ap# t?? d???a 93/68/ ??. Este equipamento obedece às exigências das directivas 89/336/CEE e 73/23/CEE, na sua versão corrigida pela directiva 93/68/CEE. Este aparato satisface las exigencias de las Directivas 89/336/CEE y 73/23/CEE, modificadas por medio de la 93/68/CEE. Denna utrustning uppfyller kraven enligt riktlinjerna 89/336/EEC och 73/23/EEC så som kompletteras av 93/68/EEC. Dette produktet oppfyller betingelsene i direktivene 89/336/EEC og 73/23/EEC i endringen 93/68/ EEC. Tämä laite täyttää direktiivien 89/336/EEC ja 73/23/EEC vaatimukset, joita on muutettu direktiivillä 93/ 68/EEC. SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or ASA and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type. DANGER:The fuse from the cut-off plug should be removed and the cut-off plug destroyed immedi- ately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet, as a serious electric shock may occur. To fit an appropriate plug to the mains lead, follow the instructions below: IMPORTANT:The wires in the mains lead are coloured in accordance with the following code: Blue : NeutralBrown : Live As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows; •The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black. •The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red. Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-pin plug. Before replacing the plug cover make sure that: •If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug. •The cord grip is clamped over the sheath of the mains lead, and not simply over the lead wires. IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.LC-20B2E LCD COLOUR TELEVISION OPERATION MANUAL ENGLISH ENGLISH Contents PagePage Dear SHARP Customer..........................................2 Important Safety Precautions.................................2 Supplied Accessories.............................................4 Preparation.............................................................5 Installing Batteries in the Remote Control......5 Using Remote Control.....................................5 Power Connection...........................................6 Antenna Connection........................................6 First Installation................................................7 Part Names of Main Unit........................................9 Part Names of Remote Control............................11 Bas... »