Notice SONY RM-V202

« la marque et la colonne droite le n° de code. To set a Component Code (see the instruction manual for details) Pour enregistrer un code d’appareil (voir le mode d’emploi pour plus dedétails) Code No.c S cc VCRTVSATDVD While pressing the S (SET) button, press the 1 button. Tout en maintenant la touche S (SET) enfoncée, appuyez sur la touche 1. Notes on Batteries •Do not mix old batteries with new ones or mix different types of batteries together. •If the electrolyte inside the battery should leak, wipe the contaminated area of the battery compartment with a cloth and replace the old batteries with new ones. To prevent the electrolyte from leaking, remove the batteries when you plan not to use the Commander for a long period of time. Setting the Code Follow steps 1 and 2 below for each component you plan to use with the Commander. Step 1: Entering the Code Number 1 See the supplied “Component Code numbers” table, and find the three-digit code number for the desired component. If more than one code number is listed, use the number that is listed first to complete the steps below. For example, if you are setting up a Philips TV, you would use the code number 086. If your component is not listed, see “Searching for the Correct Code.” 2While pressing the S (SET) button, press the 1 button. 3Press the button of the component that you want to set up. Note On the VCR, SAT and DVD buttons, “VCR,” “satellite tuner,” and “DVD player” are assigned respectively at the factory. But you can also assign other components on these buttons. For details, see “Changing the Component Type on the VCR, SAT and DVD buttons.” 4Enter the component’s code number. For example, if you are entering the code for a Philips TV, you would press -86. 5 Press and release the t button to store the code number in the Commander’s memory. 6Go to “Step 2: Checking if the Code Number Works” to finish setting up. If you press a wrong button in step 4 Press the 1 button while pressing the S (SET) button and then go back to step 2. Step 2: Checking if the Code Number Works 1 Turn on the component you want to set up. 2Aim the Remote Commander at the component and press a button to check if that button works. For example, press the 1 button to see if it works on your component. 3Check that the other buttons of the Commander are operating the corresponding functions of the component. You can write down the code number on the label inside the battery compartment lid. If the Commander Does not Seem to be Working... •First, try repeating these setup procedures using the other codes listed for your component (see the supplied “Component Code Numbers” table). •If after trying all the codes listed for your component you still cannot get the Commander to work properly, try the search method described in “Searching for the Correct Code.” Searching for the Correct Code If you have tried all the code numbers listed for your component and you still cannot get the Commander to work (or if your component is not listed in the “Component Code Numbers” table), try these steps. Before starting the Search function Set each component to the following status to enable the Search function. TV: power-on Other components: power-off 1While pressing the S (SET) button, press the 1 button. 2On the Commander, press the button of the component that you want to set up. 3Press and release the PROGR+ button. Then press and rel... »