Notice THOMSON ROC 240

« se keys to select the set you want to control. Videotext: Back to TV programme. Videotext: the videotext page recovers the TV picture. Also enables one to quit a menu (exitkey). PROG +,PROG -: gives you access to the channels (received by the TV set or the video recorder) in either ascending (+) or descending (-) order. Can also be used for vertical travelling through the menus. VOL -, VOL +: to increase (+) or decrease (-) the volume of the TV set. ZOOM-, ZOOM+:for horizontal travelling through the menus (with sets supporting this feature). FAST FORWARD PLAY PAUSE20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 This Universal Remote Control is compatible with most models of infrared-controlled TV sets and video recorders. This remote control was programmed in the factory, so that you can use it to control most of the sets of the THOMSON group's make. For this reason, we recommend that prior to attempting to programme the remote control, you try it out by means of one of the methods described in this user manual. But first of all, you'll have to load the supplied batteries into the remote control. Please keep this guide along with the code list (provided separately), so that you can subsequently programme your remote control for use with other sets. 1 - Description of the key functions 2 - Testing the not yet programmed remote control 1. Switch on the set you want to control. 2. Position the selector (13) on the type of set to be controlled: TV: television set VCR: video recorder 3. Direct the remote control towards the TV set and try to switch it off by simply pressing the key BB(1). Should the set not switch off, you'll have to programme the remote control by means of one of the methods A, B, Cor Ddescribed hereinafter in chapter 3. ROC 240 16/05/01 17:07 Page 1GB 2 3 - Programming the remote control Method A – Fast programming with 1-digit subcode Method B – 3-digit codes programming Before you start programming, you must find the subcodeof the set to be controlled (TV set or video recorder). Refer to the list provided with these instructions, page I of the subcodes. 1. Switch on the set you want to control. 2. Position the selector (13) on the type of set to be controlled: TV: television set, VCR: video recorder 3. Hold down the key SHIFT(4) until the red indicator lamp (11) remains lit (the indicator lamp remains on for a couple of seconds, so that you have time enough to proceed with steps 4 to 6. The indicator lamp flashes to signal that this time is almost up, and then goes off). 4. While the indicator is lit, type in the subcode (example: 1for THOMSON). 5. Direct the remote control towards the setand try to switch it off by pressing the key BB(1). 6. Immediatelyupon the switching-off of the set to be controlled, press OK(7) to store the subcode. 7. Should the set not switch off, press key BB(1) repeatedly, until the set switches off. Between two subsequent key depressions, give the red indicator lamp (11) enough time to extinguish and light up again(about 1 second). Proceeding this way will enable you to see whether the set responds or not. 8. Immediatelyupon the switching-off of the set to be controlled, press OK(7) to store the subcode. Check of the programming In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Before you start... »