Notice LENCO DPA-35

« e ** Important: Install application software before connect device to PC. ** 1. Disconnect device USB cable from PC if it is connected. 2. Insert CD and follow the on-screen instruction to install “Photo Album”. 3. After the application software has been successfully installed, you could connect device to PC with the provided USB cable. 4. Windows OS will set up hardware driver automatically. 5. Launch “Photo Viewer” and enjoy. NOTE: The software can not initialize with the unit if plugged in while running in automatic slide show mode. 2 Downloaded from www.Manualslib.com manuals search engine Important Safety Instructions Introduction This Digital Photo Album is a stand-alone device that is designed to transfer and store images from a PC and then display the images. Using the application software supplied with this device, you can organize, edit, enhance and download the images in your PC to this device using USB. WARNING: This device will be fully charged after three hours.Do not leave the device connected to the USB for longer than 12 consecutive hours otherwise damage and overheating of the device may occur. Do not expose this device to water or moisture. The device should be situated away from sources of high heat such as radiators or stoves. The device should be connected to a power supply only of the type described in the operating instructions or as marked on the unit. Care should be taken so that objects are not placed on, nor liquids spilled on or inside the device. The user should not attempt to service the device beyond those means described in these operating instructions. All other servicing should be referred to qualified service personnel. 3 A fully charged battery gives about 2.5 hours of playtime, when the battery is low, "Low Battery" appears on the display and the Photo Album shuts down in about 10 seconds. Following these steps to charge the battery. Charging the Built-In Battery Downloaded from www.Manualslib.com manuals search engine Installing the Software / Hardware IMPORTANT: You must install the software to your computer before connecting the device to your computer for the first time. 1. Insert the CD-ROM and run the file SETUP.EXE; Follow the on-screen instructions. 2. The application Photo Viewer will be installed on your computer and a short cut to the application will appear on your desktop. DO NOT LAUNCH THE SOFTWARE YET. 3. After the software is installed, connect the device to the computer with the USB cable supplied. The hardware drivers will be installed automatically. Follow the on-screen instructions and accept the installation screens that appear. 4. After hardware installation is complete, launch the Photo Viewer application from the shortcut on your PC desktop. NOTE: If you are unable to launch the software or connect to your Photo Album, go to the Troubleshooting of the manual for more information. 1.InsertoneendoftheUSBcableintoUSBonPhotoAlbumandthe otherendintoyourcomputer'sUSBport.Thebatterylevelindicator flashesonthedisplay. 2.Chargingtimeisapproximatelythreehours,whenthebatteryis fullycharged, thebatterylevelindicatorstopsflashing. 4 Downloaded from www.Manualslib.com manuals search engine Downloading Photos From PC to Digital Photo Album 1. Connect to PC UsetheUSBcableprovided.Co... »