Notice BIONAIRE BCH4051

« IUK04M2 visual.qxd 6/25/04 9:08 Page 1E B C DA English2 Deutsch/German4 Français/French6 Español/Spanish8 Nederlands/Dutch10 Svenska/Swedish12 Suomi/Finnish14 Norsk/Norwegian16 Polski/Polish18 EKKHNIKA/Greek20 "esky/Czech22 Magyar/Hungarian24 PYCCKNÑ/Russian26 Figure 1 BCH4051 BCH4051I/IUK04M2 visual.qxd 6/25/04 9:08 Page 43.The thermostat will now automatically maintain the temperature at the required heat level. AUTO SAFETY SHUT OFF The heater has a built in safety device which will switch off the heater automatically in case of accidental overheating. It can only resume operation when the user has reset the unit. To reset the heater 1.Turn the control switch to the 0 (OFF) position. 2.Unplug the heater and wait for 15-20 minutes for the unit to cool down. 3.After the 15-20 minutes, plug the unit in again and operate normally. CLEANING AND MAINTENANCE •Turn the switch to the 0 (OFF) position. •Remove the plug from the wall socket. •Wait for the heater to cool down sufficiently. •You may clean the outside of the heater with a damp cloth. Do NOTallow water to come into the appliance. Do NOTuse soap or chemicals, which may damage the housing. Allow sufficient time to dry before plugging the unit back in the socket. •Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. STORAGE TIPS If you do not plan to use your heater for an extended period of time (i.e. during the summer months), we recommend you to re-pack the unit in its original packaging or any other dust-free packaging and store it in a dry and cool place. For U.K.and Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please refer to "Installation of a plug" below. Installation ofa plug Applicable to U.K.and Ireland The wires in the mains lead are coloured as such: BROWN-LIVE BLUE-NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. DO NOTCONNECTeither of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E", or with the earth symbol or coloured GREEN, or GREEN and YELLOW. NOTE:If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A3-pin plug is fitted, it must be an ASTAapproved plug, conforming to BS1363 standard. Replacement 13 Afuses must be BSI or ASTABS1362 approved. GUARANTEE PLEASE KEEPYOUR RECEIPTAS THIS WILL BE REQUIRED FOR ANYCLAIMS UNDER THIS GUARANTEE •Your heater is guaranteed for 2 years. •In the unlikely event of breakdown, please take your heater back to the place of purchase, with your till receipt and a copy of this guarantee. •The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. •Holmes Products Europe undertakes within the specific period, to repair or replace free of charge, any part of the appliance found to be defective provided that:- •... »