Notice BOSCH TDA5660 disponible gratuitement après inscription

Extrait de la notice

er. Use this function approximately every 2 weeks, if the water in your area is very hard. 1. Unplug the iron from the mains socket, set the steam regulator to the position and ?ll the water tank with water. 2. Set the temperature selector to the “max” position and plug in the iron. 3. After the necessary warm-up period, the pilot light goes out. Then, unplug the iron. 4. Hold the iron over a sink. Press the “clean” button and gently shake the iron. Boiling water and steam will come out, carrying scale or deposits that might be there. 5. When the iron stops dripping, release the button, plug the iron in and heat it up again until the remaining water has evaporated. 6. Repeat the process if the iron still contains impurities. 3. anti-calc The “anti-calc” cartridge has been designed to reduce the build-up of scale produced during steam ironing, helping to extend the useful life of your iron. Nevertheless the “anti-calc” cartridge cannot remove all of the scale that is produced naturally over time. “Secure” auto shut-off function Fig. 9 (Depending on model) The “Secure” auto shut-off function switches off the iron when it is left unattended, thus increasing security and saving energy. After plugging in the appliance, this function will be inactive for the ?rst two minutes in order to give the appliance time to reach the set temperature. After such time, if the iron is not moved for 8 minutes while in the upright position or 30 seconds while resting on its soleplate or on its side, then the safety circuit will switch the appliance off automatically and the pilot light will start ?ashing. To reconnect the iron, just move it about gently. Drip protection (Depending on the model) lf the temperature is set too low, t...