Notice PIONEER DEH-1600R

Notice PIONEER DEH-1600R disponible gratuitement après inscription

Accédez à la notice du PIONEER DEH-1600R en adhérant à la communauté.

Notice d’utilisation de votre PIONEER DEH-1600R. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre DEH-1600R.

Notices - manuels - modes d'emploi disponibles pour PIONEER DEH-1600R après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

ect the wiring,wrap adhesive tape around them where they lie against metal parts. •Route and secure all wiring so it cannot touch any moving parts,such as the gear shift,hand- brake and seat rails. Do not route wiring in places that get hot,such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. •Don’t pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. •Do not shorten any leads. If you do,the protec- tion circuit may fail to work when it should. •Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capac- ity of the lead will be exceeded,causing over- heating. •When replacing fuse,be sure to use only fuse of the rating prescribed on this product. •Since a unique BPTL circuit is employed,never wire so the speaker leads are directly grounded or the left and right ?speaker leads are com- mon. •Speakers connected to this unit must be high- power types with minimum rating of 45W and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire,emitting smoke or becoming dam- aged. •When this product’s source is switched ON,a control signal is output through the blue/white lead. Connect to an external power amp’s system remote control or the car’s Auto-antenna relay control terminal (max. 300 mA 12 V DC). If the car features a glass antenna,connect to the anten- na booster power supply terminal. •When an external power amp is being used with this system,be s...

En cours...