Notice DORO Phone Easy Record 327CR disponible gratuitement après inscription

Extrait de la notice

imately two signals. This is useful when using remote access: if there is no answer after three rings there have been no messages recorded and you can hang up before you are charged for the call. If however the machine does answer after two rings, there are new messages.8 English Technical InformationOn the right side of the telephone there is a switch for Flash time.Flash time (100/300/600).100 is the standard setting for most countries including the UK. TroubleshootingCheck that the telephone cord is undamaged and properly plugged in. Disconnect any additional equipment, extension cords and other phones. If the problem is resolved, the fault is with some other equipment. Test the equipment on a known working line (e.g. at a neighbour’s house). If the equi?ment ?or?s there then the fault is probably with your telephone line. Please report this to your network operator. The answer machine is not answering- Check that the unit is switched on. - Check that the telephone cable and the mains adapter are correctly connected. The answer machine does not respond to remote access- Check that the telephone you are using to remotely access the answer machine is a tone dialling telephone. - Some telephones only emit a short tone beep when buttons are pressed, and this may not be enough to activate remote access. Use a separate tone transmitter in these cases. - Also try holding the buttons down longer, approximately 1 second per digit. I can’t hear the outgoing message very well- Record a new outgoing message. - Speak closer to the microphone when recording. The microphone is located under the handset on the front of the telephone. The line is disconnected when someone leaves a message:- An incoming message may be up to 120 seconds in length. After this time, the call w...