Notice LEXIBOOK ST050

« x AAA/LR03 alkaline batteries (not included). To do so, open the battery compartment located at the back of the remote. Make sure to install the batteries according to the polarity (+/- signs) indicated inside the battery compartment. Close back the battery compartment. Notes: Your remote control will not lose its settings when the batteries are out of power. When changing the batteries, do not press any key on the remote control. Else, the remote control’s settings will be affected. DVD – DVD player selection and set key. VCR – VCR selection and set key. TV1 – TV selection and set key. AUX – Hi-Fi system selection and set key. SAT – Satellite TV receiver selection and set key. M1/M2/M3 – Macro keys. Using the buttons and functions Once you complete the setup procedure, the Lexibook® Universal 5 in 1 Remote Control will allow you to control the various audio-video devices you have at home. When you use the remote, ?rst select the type of device you wish to use by pressing the corresponding device key (TV, DVD, SAT, VCR or AUX). Aside from the 5 device keys and the macro keys, all other keys on the remote control are only operative if your device also has these functions. For example, the pause key (), will work in CD mode but not in TV mode. SET – to trigger setting mode. LIGHT – to enable the backlight. The red (R), green (G), yellow(Y), and blue (B) buttons can have various functions depending on whether your TV set supports these applications. ST050.indd 317/8/07 18:24:56Copyright © Lexibook 2007 4 ENGLISH If your device cannot be programmed using manual setup or its code is not in the list, program your remote control using the quick or auto search function. The search function tests all the codes one after another and ?nds the right one for your device. Quick search This search should be used only if Manual search failed or if the brand or correct model code are missing. 1. Switch on the device to be set to the remote and aim the remote control at the device. - If VCR, insert a cassette. - If SAT, select a program. - If DVD, insert a DVD. 2. Press the SET key followed by the respective device key on your remote control. Hold down both keys. 3. When the LED lights up, release the buttons. 4. Press the SET button again. The LED starts ?ashing and quick code search starts. 5. In order to trigger the code search you will have to push the POWER key ( ). 5 codes will be transferred. Wait 3 seconds. If nothing happens, press Power again. Each time the power key is pressed, it will look for 5 new different codes during 3 seconds. You may need to press the power key up to 100 times maximum. (approximately 5 minutes). 6. When your device switches off, the correct code has been found. DO NOT press the POWER button again, as this would restart the code search. 7. Press the respective DEVICE button again to exit the current stage. The LED stops blinking and remains solid. 8. Return to your device and switch it ON again (by using original remote control or the device’s front panel buttons). 9. In order to ?ne tune the search within these 5 codes, you must press the power key and wait 2 seconds. If nothing happens, repeat by pressing power again and wait 2 seconds. If your device still does not respond, you should only need to press the power key 5 times in total before your device turns back OFF... »