Notice BIONAIRE BFH251

« E CONSOMMATEURS 0 825 85 85 82 FAN HEATER BFH251 INSTRUCTION MANUALNOTICE D’UTILISATION BETRIEBSANLEITUNG MANUAL DE INSTRUCCIONES MANUAL DE INSTRUÇÕESMANUALE D'USOINSTRUCTIEHANDLEIDING BRUKERHÅNDBOK KÄYTTÖOPAS BRUKSANVISNINGBRUGERVEJLEDNING INSTRUKCJA

  ??????????? ?? ???????????? HASZNÁLATI UTASÍTÁSNÁVOD K OBSLUZE ©2006 JCS/THG, LLC Bionaire®and the Bionaire logoTMare trademarks of JCS/THG, LLC.BATHROOM USE UK ONLY: •Regulations prevent the use of this heater in the bathroom. IN OTHER COUNTRIES •If this heater is going to be used in a bathroom, or similar room, it must be installed: a.In such a way that the switches and other controls cannot be touched by the person in the bath or shower. b.Outside the grey shaded areas (Fig 3 and 4) •If you are unsure about the installation of this heater in the bathroom we recommend that you seek advice from a professional electrician/installer. Safety in use •Extra caution is necessary when the heater is used near children or when it is left unattended. •DO NOT insert any objects into the heater. •Keep the mains cord at a safe distance from the main body of the heater. •Prevent overheating of the heater by keeping the air inlet and outlet unblocked.DO NOT hang anything in front of or above the heater. •If overheating should occur, the built-in overheating safety device will switch off the heater. •DO NOT use aerosols, inflammable substances or materials sensitive to heat in the flow of hot air. •Do not place the cord under a rug. Servicing •Should the heater stop working, first check the fuse in the plug (UK only) or fuse / circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. •If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. •The heater contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or their service agent. For U.K.and Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type.Please refer to "Installation of a plug" below. Installation ofa plug Applicable to U.K.and Ireland The wires in the mains lead are coloured as such: BROWN-LIVE BLUE-NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug.Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. DO NOT CONNECT either of these wires to the earth terminal in the plug.The earth terminal plug is marked with the letter "E", or with the earth symbol or coloured GREEN and YELLOW. NOTE:If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard.Replacement 5 A fuses must be BSI or ASTA BS1362 approved. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE. •This product is guaranteed for 2 years. •In the unlikely... »