Notice IQUA Vizor

« ren since it contains small parts that may pose a choking hazard. Car Installation You can attach your Vizor to the sunvisor of your car with the sunvisor clip as shown in Fig. a. Make sure that the product is not in the operating area of any side impact airbags or any of the other safety or operating equipment in your car. In addition, check that the product is securely fastened and does not interfere with you being able to operate the vehicle. Charging the battery Before using Iqua Vizor, you must charge it for approximately 3.5 hours. Always use the charger that comes in the sales package. 1. Connect the charger cable to Vizor. 2. Plug the car charger into the cigarette lighter in your car. The light will turn on. 3. The light will turn off once the battery is fully charged. Vizor indicates that its battery is low with a warning sound and a ? ashing light. Switching on and off To switch on VIzor: • Press and hold the button until the all the lights go on and you can hear a sound. The button lights stay on for some time. • To switch off Vizor, press and hold the button until the lights go off and you can hear a sound. If the Vizor is switched on but without any Bluetooth connection, the Vizor will shut down after some time. Pairing the Vizor and a mobile phone Pairing is the process of linking your handsfree to a Bluetooth-enabled mobile phone*. Once this process is over, you will be able to use the Vizor with the mobile phone you have paired it to. If you want to use the Vizor with another mobile phone, you must repeat the pairing process again. Even though the Vizor can be paired with up to 8 compatible phones, it can only be connected to one phone at a time. * For the latest compatibility information please visit www.iqua.com. 1. When power is off, press and hold down the button until you hear a sound and the light starts ? ashing. 2. Release the button. The Vizor is now in pairing mode and is waiting for your mobile phone to contact it. 3. Complete the pairing with your mobile phone. Please refer to your mobile phone's manual for details on how to search and pair. Once the mobile phone has found the handsfree device, the phone will show Iqua Vizor on its display. In order to pair with the phone, enter the PIN code of the Vizor, which is 0000. 4. After pairing, the Vizor will automatically connect to your mobile phone. Once they have been successfully paired and connected, you will hear a sound and the light will stay on. Reconnecting the paired Vizor to a phone To reconnect the Vizor to the last phone used, simply switch on the Vizor and it will automatically connect to the phone. Disconnecting the Vizor from a phone Easiest way to disconnect Vizor and your phone is simply to switch off the Vizor. Call Functions Answer a call When there is an incoming call, you will hear the ringing tone through the Vizor speakers. To answer a call, just press the button brie? y. End a call To end an active call, press the button brie? y. Reject a call When you receive an incoming call that you do not want to answer, simply press the button brie? y. You will hear a sound when the call is rejected. Redialling the last number dialled To place a call to the last number dialled, press the button brie? y. You will hear a sound when the call is in progress. Using Fast call function To save your favourite number: When... »