Notice OAKLEY Holeshot

« SHOT INSTRUCTION MANUAL 03 SETTING THE TIME The crown can be pulled out to two click positions for setting the date and time. To set the date and time the first time(or to reset the date and time after the battery is changed), do the following: TO SET THE TIME 1.Pull the crown out to the first click position (a). 2.Turn the crown until yesterday’s date appears. 3.Pull the crown out to the second click position (b). 4.Turn the hands forward until today’s date appears, then continue forward until the current time is reached. If the current time is in the afternoon or evening, move the hour hand all the way around the dial to pass 12 o’clock noon. 5.Push the crown back down. Toset the exact second, wait until the hand in the second-counting sub dial (at the bottom of the main dial face) reaches “60” before you pull out the crown. Set the time then wait until the exact second is reached before pushing the crown back down. ABAB Button A Button B Date CrownTOADJUST THE TIME AND DATE FOR SUBSEQUENT SETTINGS, USE THESE SHORT PROCEDURES TO SET THE TIME 1.Pull the crown out to the second click position (b). 2.Turn the crown until you reach the correct time. 3.Push the crown back down. TO SET THE DATE 1.Pull the crown out to the first click position (a). 2.Turn the crown until you reach the correct date. If the current time is between 9 PM and midnight, set the date to the following day.(This is necessary to ensure the date display will normally change at midnight instead of 12 noon.) 3.Push the crown back down. 04HOLESHOT INSTRUCTION MANUAL AB Button A Chronograph 1/10 Second Chronograph Minutes SecondsChronograph Second Hand Button B Date CrownHOLESHOT INSTRUCTION MANUAL 05 USING THE CHRONOGRAPH The chronograph includes three separate hands: •The narrow hand on the main dial face counts seconds. One full rotation is 60 seconds. •The hand on the sub dial at the left counts minutes. One full rotation is 30 minutes. •The hand on the sub dial at the right counts 1/10 seconds. One full rotation is 1 second. The chronograph is controlled with two push buttons: •Button “A” stops and starts the timer. •Button “B” has several functions. In addition to pausing the display at the current intermediate or “split” time, it allows the chronograph hands to catch up to the ongoing time being measured, and it resets the chronograph hands to the zero position. Before using the chronograph functions, make sure the crown is fully against the case and not at one of the click positions used for setting time and date. The three chronograph hands should align precisely at the zero position. If they do not, see the section on Adjusting the Chronograph Hands.TO MEASURE CUMULATIVE TIME START TIMING Press button “A”. STOP TIMING TEMPORARILY Press button “A” to stop timing temporarily. Press button “A” again to restart timing. Continue to use button “A” to add additional time intervals to the total measure of time. When using button “A” only, the time that occurs while the chronograph hands are not moving IS NOT ADDED to the total measure of time. See the section on “To measure intermediate time” if you wish to include this “intermediate time” in the total measure of time. RESET While timing is stopped, press button “B”. 06HOLESHOT INSTRUCTION MANUAL AB Button A Button BTO MEASURE INTERMEDIATE TIME / SPLIT TIMEGUARDING START TIMING Press button “A”. PAUSE HANDS BUT C... »